March 18, 2021

Precautions for safe operation of spiral sand washer

In the sand washing plant, Large spiral sand washer is usually used, which consumes a lot of energy in production and operation. If the equipment is not operated properly, it may cause great damage to the equipment.


Ⅰ.Precautions before operation
1. First, it is necessary to confirm whether the lubrication system of sand washing machine is normal operation and whether the pipeline is smooth and complete.
2. Confirm that the sand washing machine is connected correctly before connecting the power supply
3. After the sand washing machine is started, it is necessary to confirm whether the transmission system of the spiral sand washer can operate normally, whether it has complete speed change device and whether the electrical system is reliable.
4. Confirm whether the spiral part of the spiral sand washing machine operates normally, whether there is pulling, bumping or crack damage, if there is any damage, it should be replaced in time.
5. If there are other equipment in front of the sand washing machine, the sand washing process should start each equipment in sequence, and the starting interval between each equipment should be greater than 5 seconds. After all the equipment are started, it should run for 5 minutes.
6. After confirming the above steps, fill the water tank with water and add a small amount of material in the sand washing machine, so that the sand washing plant can start light load operation. After confirming the correctness, it can be adjusted to the normal working output.

Ⅱ. Operation precautions in operation
1. During the operation of the spiral sand washer, try not to use the emergency button.
2. In case of blockage, material jam, overload and other faults, the spiral sand washer should be stopped immediately. Before stopping, the spiral body of the sand washer should be lifted out of the slurry, and then the discharge valve should be opened quickly, so as to avoid material blocking the sand washer.
3. After troubleshooting, lower the spiral body of sand washer to the designated position, and then start the machine
4. If the sand washing plant fails to stop, the vibrating feeding mechanism should be stopped first, and the feeding should be stopped from the source. After the material classification on the conveyor belt is completed, the operation of each equipment should be stopped.
5. The lubricity of the sand washer bearing should be maintained, and high pressure oil should be injected into the bearing every 4 hours, so as to ensure the sealing of the bearing.

The above introduces the precautions of spiral sand washing machine before and during operation. The operators should strictly follow the operation process when operating the equipment to avoid damage and reduce the service life of the equipment.

Lasted news & technology
Apr 21 2021

The application of silicon powder in the electronic industry is mainly reflected in the following points.

Apr 20 2021

As an important industrial raw material, quartz sand is used more and more widely.

Apr 19 2021

The hindered settling classifier realizes the natural separation of coarse particles and fine sand under the action of strong water pressure.

Apr 18 2021

The quality requirements of PV glass sand are mainly reflected in three aspects: chemical composition, particle size and refractory heavy minerals.

Apr 17 2021

So, how to purify quartz sand? Now we summarize the following common quartz sand purification methods.

Apr 16 2021

In order to extend the service life of the silica sand magnetic separator, SINONINE summarizes the following aspects for users' reference.

Apr 15 2021

The following are the daily maintenance points of the vertical ring high gradient magnetic separator summarized by SINONINE for customers to guide production.

Apr 14 2021

In order to better improve the dewatering effect of the dewatering screen, SINONINE tech team suggests that the following factors should be fully considered.

Contact us

Thank you for your interests in Sinonine, Please feel free to submit your inquiry information to us, our expert will contact with you as soon as possible.

Name
Email
Tel
Country
Message
sinonine@9silica.com
+86-25-58875679
+86-18118821087